Wave MLS3-D full frequency acoustic body

1: MLS three-dimensional acoustic slot, combined with Helmholtz large volume low-frequency absorption cavity, ultra wide low-frequency absorption capacity, as low as 150Hz

2: MLS three-dimensional space full efficiency quantization waveform, combined with MLS double frequency range diffusion technology, full frequency diffusion of sound wave, to obtain uniform diffusion sound field;

3: Patented quantized waveform algorithm and single asymmetrical WAVE waveform structure to eliminate periodic effects

4: It has the trinity of diffusion, sound absorption and Helmholtz low frequency absorption.

5: Main body GRP reverse molding, one-time molding, high strength, high hardness, high density, no loss of sound energy;

6:Pu piano baking finish.

7: European EO environmental protection standard;

8: It's easy to install. Four screws can do it,

9： Standard modular acoustic solution for acoustical brightness ° 1.0

10：Size：600*600*100mm（H*W*D）

Installation method:

1. With the back of the product facing up, there are 8 screw holes on the edge around the product, as shown by the arrow below：

2. Turn the product over and face up. If the product is brand new and not installed, screw holes can not be seen on the edge around the front, as shown in the figure below：

3: The screw holes can be punctured with the attached screws. In general, you only need to select 4 screw holes to punch, which can firmly fix the product to the wall or ceiling. You don't need to punch all the 8 screw holes, which is redundant and unsightly, as shown in the figure below：

4: Most of the time, your wall or ceiling is made of cement. We suggest that you nail a board on the surface of the cement, so that you can use the four screws attached to fix the product to the board, as shown in the following figure:

5:You can also use wooden keel instead of wood board:

1. When multiple products are installed continuously